Anaren Microwave Plating Operator - 2nd shift (2013294)" in Littleton, Colorado
Plating Operator - 2nd shift (2013294)" />
Plating Operator - 2nd shift
To perform various electroplating processes to deposit metals on printed circuit boards. Must be able to read and follow written directions on shop travelers and work instructions that are in place for each process. Must adhere to all health and safety guidelines, including requirements for keeping the area clean and organized. Required to utilize all appropriate safety equipment and to receive annual RCRA and safety training.
PRINCIPAL DUTIES AND RESPONSIBILITIES:
Maintaining a clean work environment
Product verification of panels processed
Environmental regulations for proper chemical handling and storage of chemicals
Preventive maintenance on equipment
Check levels of chemical baths
Operate repetitive plating and wet process machines to plate circuits onto panes, e.g., deposition process
Manually performs or operates machines requiring setups, constant monitoring and periodic adjustments in speed, temperature and/or chemical levels
Set appropriate speed on conveyor and run product in the most efficient manner
The employee is responsible to follow all RCRA standards as outlined by the certification that he or she has been trained to at all times. The health and safety regulations encompass the cleanliness of the area that he or she will be working as a result
May handle hazardous waste as outlined in departmental work instructions
The following RCRA training is required on initial hire and on an annual basis thereafter Introduction to RCRA, Properties of Facility Waste, Waste Minimization Accumulation, Container Management, and Emergency Response Plan
Solid knowledge of math
Strong attention to detail
Knowledge of chemistry and electroplating processes preferred
Ability to work around chemicals
Good computer skills
Ability to perform visual inspection
PCB manufacturing experience preferred, but not required
Ability to produce quality work under pressure
Able to understand and follow daily work direction and process instructions in English as received verbally or in writing from supervisor or other qualified person
Ability to understand and follow posted procedures
Ability to understand and follow all safety codes and requirements
Ability to lift up to 50 lbs. and work in noisy environment (hearing protection provided)
Ability to work in chemical environments
Ability to stand on feet for 8 hours
Meet all safety requirements for performing duties.
*Unicircuit is a drug-free facility. All candidates must be able to pass a drug test.
Education: H.S. diploma or GED required.Experience: General manufacturing experience helpful. Previous electroplating or printed circuit board manufacturing experience preferred.
Must be eligible to work on defense and satellite programs subject to ITAR Regulations. Therefore, candidates must be U.S. Citizens or U.S. Permanent Residents ("Green Card").
Unicircuit is a VEVRAA/Federal Contractor and EEO/AA Employer, including disabled and veterans.
Littleton, Colorado, United States